Dialogic DSI SPCI Network Interface Boards Dokumentacja Pobierz pdf (Strona 33)

Dialogic

DSI SPCI Network Interface Boards Programmer's Manual Issue 7

Format

MESSAGE HEADER

Field Name

Meaning

type

LIU_MSG_CONFIG (0x7e34)

liu_id

src

Sending Module ID

dst

MVD_TASK_ID (0x10)

rsp_req

used to request a confirmation

hclass

status

Status Response (if confirmation requested)0

err_info

len

PARAMETER AREA

Offset

Size

Name

liu_type

line_code

frame_format

crc_mode

build_out

faw

nfaw

Reserved for future use, must be set to zero.

ais_gen

rai_gen

Reserved for future use, must be set to zero.

clear_mask

Reserved for future use, must be set to zero

Description

This message is sent to the DSI SPCI Board to configure the operating mode a line

interface unit. All configuration parameters must be supplied in the message (it is not

possible to modify individual operating parameters in isolation). On receipt of the

message the board first verifies that the fitted hardware options support the requested

operating mode and then initializes (or re-initializes) the line interface unit.

The confirmation message (if requested) indicates success by status of zero.

Parameters

A description of the permitted parameter values are given below. When the DSI SPCI

Board is initially configured all the line interfaces are initialized to a disabled condition.

liu_type

The physical type of interface according to the following table. The preferred method

for configuring an E1 interface is to select liu_type=5.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 73 74

Komentarze do niniejszej Instrukcji

Brak uwag

Dialogic DSI SPCI Network Interface Boards Dokumentacja Strona 33

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Dialogic DSI SPCI Network Interface Boards