
4 Message Reference
20
4 Message Reference
4.1 Overview
This section describes the individual messages that may be sent to and received from
the Dialogic
®
DSI SPCI Network Interface Board. Some messages are sent by the
user's application software whilst others are sent by utility programs such as the
s7_mgt protocol configuration utility.
Prior to sending any message to the board, the application should call the
GCT_set_instance( ) library function to select which board the message will be sent
to. After receiving a message from the board, the application should call the
GCT_get_instance( ) library function to determine which board the message came
from. These library functions are described in the Software Environment Programmer's
Manual.
The various messages used are grouped in the following categories:
General Configuration Messages
Hardware Control Messages
Event Indication Messages
Status Request Messages
4.1.1 Message Type Summary
The following table lists, by message type, the messages described in this manual:
Table 4: Message Summary
MTP2 Level 2 State Indication
MTP2 Q.752 Event Indication
MTP3 Q.752 Event Indication
s7_mgt Completion Status Indication
Confirmation of LIU_MSG_R_CONFIG
Confirmation of LIU_MSG_R_CONTROL
Confirmation of LIU_MSG_R_STATE
Confirmation of MTP_MSG_CNF_ROUTE
Confirmation of SSD_MSG_RESET
Confirmation of SSD_MSG_RST_BOARD
Confirmation of MVD_MSG_RESETSWX
Komentarze do niniejszej Instrukcji