Dialogic DMG2030DTI Instrukcja Użytkownika Pobierz pdf (Strona 9)

TCP/UDP

UDP/TCP Transport enabled: Yes

TCP/UDP Server Port: 5060

TCP Inactivity Timer (sec): 30

TLS

TLS Transport Enabled: No

Proxy

Primary Proxy Server Address: <Blank>

Backup Proxy Server Address: <Blank>

Monitoring

Monitor Call Connections: No

Routing Table

The routing table describes a set of rules used to define the characteristics of a call routed through the

gateway. The primary characteristics include the destination address and the CPID (call party

identification) information. The dial plan affects calls originating from the VoIP side, and calls

originating from the TDM (T1, E1, analog, and so on) side.

TDM Trunk Group

The TDM Trunk group will be used to route calls between the attached PBX and the UC server. Using

regular expressions or wildcard characters you can define the range of ports that you will use.

To configure the TDM trunk group, follow these steps:

1. Using the left-hand menu navigate to Configure > Routing Table.

2. Select the TDM Trunk Groups radio button.

3. Ensure that entries for both voice and message waiting ports are included. The following table

shows some possible values.

4. Select Submit.

Option Name

Voice

Message

Waiting

Name

Any

TdmMwis

Selection Direction

Ascending

Descending

Selection Mode

Linear

Port/Channel Content

Note: The Port/Channel content can also include a restricted range of ports. The default configuration is

the * character (for all channels)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Brak uwag

Dialogic DMG2030DTI Instrukcja Użytkownika Strona 9