Dialogic 4000 SERIES Instrukcja Użytkownika Pobierz pdf (Strona 36)

Dialogic

4000 Media Gateway Series Reference Guide

Page 36

You can configure the following parameters in the General section when you define or modify a SIP Peer:

Name: Enter a name for the SIP peer. A SIP peer is a specific endpoint to and from which Diva SIPcontrol

can establish calls.

Peer type: SIPcontrol needs special workarounds to work properly with some SIP peers, such as Microsoft

Exchange Server. If this is the case for your configuration, select the specific SIP peer. If not,

select Default.

Host: Enter the host name or IP address of the peer. The name must be resolvable by local name

resolution. During the establishment of a call, the host name is sent by this peer exactly as entered

here, unless an address map applies that converts the host name to a different format. For more

information about name resolution, see the Windows

documentation.

Port: Displays the SIP port on which the remote peer is listening. The default is 5060, which is the

standard port for SIP.

IP protocol: Select the IP protocol to be used for calls to this peer. Calls from this peer are accepted with all

protocols and on all ports/addresses configured in Network Interfaces

, as described on page 34.

If you selected:

• MS Exchange 2007 or MS OCS 2007/2007 R2 - Mediation Server as the Peer type, set

the protocol to TCP.

• MS Lync 2010 - Mediation Server as the Peer type, set the protocol to TCP or TLS.

• e-phone, as the Peer type, set the protocol to UDP.

URI scheme: This option is only available if you selected TLS as the IP protocol.

Calls are transmitted via various proxy servers. Some of them do not transmit the calls as

encrypted calls. If you select SIP (default), you allow calls to be transmitted via proxy servers.

To make sure that a call is sent encrypted to the proxy of the remote side, select SIPS (secure

SIP). If the call is routed via a proxy server that is not able to route the call encrypted, it rejects

the call and the call is sent to another proxy until it can be transmitted.

Domain: Enter the domain name, e.g., dialogic.com, or the IP address. The domain name must comply

with the DNS rules. The domain name entry here is only needed if the SIP peer does not use its

hostname as the source domain when it places a call.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 167 168

Brak uwag

Dialogic 4000 SERIES Instrukcja Użytkownika Strona 36