Dialogic 2000 Series Instrukcja Użytkownika Pobierz pdf (Strona 7)

• In the VoIP -> Media page:

o Set the Audio Compression parameter to match IBM Lotus Sametime Unified

Telephony requirements (the default is G.711u/G.711a).

o Set the RTP Digit Relay Mode parameter to match IBM Lotus Sametime

Unified Telephony (the default is RFC2833).

o Set the RTP Fax/Modem Tone Relay Mode parameter to match IBM Lotus

Sametime Unified Telephony (the default is RFC2833)

o Set the Signaling Digit Relay Mode parameter to ‘Off’ (the default is On)

o Set the Voice Activity Detection parameter to ‘Off’ (the default is On)

o Set the G.711 Frame Size to match the requirement of IBM Lotus Sametime

Unified Telephony (the default is 30ms).

4.4 Routing Engine Configuration

In this step, we will configure the routing table to handle inbound PSTN TDM calls destined for

IBM Lotus Sametime Unified Telephony VoIP, as well as inbound VoIP calls destined for VoIP

users, as well as inbound VoIP calls destined for the PSTN.

NOTE: For all the examples in this document going forward the term ‘inbound call’ refers to a call

in the TDM to IP direction and the term ‘outbound call’ refers to a call in the IP to TDM direction.

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Dialogic 2000 Series Instrukcja Użytkownika Strona 7